PCI-e Riser problem …

Salut, trimite-mi un mail aici https://1stminingrig.com/hire-me/, imi este mai usor asa, am sute de solicitari pe zi 🙂

Salut, eram sigur ca esti roman :). As avea nevoie de putin ajutor ma poti adauga pe facebook sa fie mai lejera discutia?
https://www.facebook.com/mariuscatalin.tranca

Hi Ciprian,

Firstly thanks for the guides. Very helpful indeed!

I just wanted to confirm to you that I can run your settings on my Sapphire Nitro+ RX 570 8GB OC cards. So your 580 settings seem to be fine for 570 as well.

It bumped up my MH/S from ~24 to ~28 immediately. I have not done any BIOS updates either so this is fine for now.

The key point is to hard wire the options you mentioned in the last part of this article. This ensures that whenever claymore reboots, it will use the same settings.

The only diff is I am using -cvddc and -mvddc of 875 rather than 850. I
am also setting the fans at ~50% which keeps the cards down to a cool
temp of 50c (using wattman).

I must also tell you that these settings let my cards run at an awesome ~80w according to GPU-Z (my watt meter is on the way so I cant confirm what it is at the wall).

Additionally, I havent tried any other clock settings yet, perhaps I can get some more juice out of them with some other combi.

A friend mentioned to me that under powering can damage the cards so any pointers u have seen on how u get whats a good number or its just trial and error? Thanks in advance.

No need to flash again the bios if drivers are uninstalled or installed.

Adauga valorile astea in fisiereul start.bat din claymore

Never faced such problem :/

I installed the new driver succesfully.

after trying to install atikmdag patcher pc crashed, and i had to make a format.

any ideas?